see all

Heater for boiler 2000 W - LAVABO - 5/4 inch

Watch the product:
Add feedback:

Code: 5750
Manufacturer: LAVABO
Manufacturer's code: 5906286363332
Weight: 1.50 kg
Availability: None

Net Price: €35.64 €43.84
szt.
Payment in cash, Payment via bank transfer, Online Payments Payment Cards, ApplePay, Google Pay - P24, PayPro SA, Osobista płatność przy odbiorze, Płatność odroczona (tylko dla zweryfikowanych Klientów), eService (card or bank transfer), Zapłacę przy odbiorze listonoszowi, Payment by bank transfer - wait for the proforma invoice to be sent, Zapłacę przy odbiorze kurierowi Inpost
Fast Blik payments.

The product is shipped within 24 hours.

We complete the order within 24 hours.

You can return the product within 14 days.

HEATER FOR LAVABO BOILER 2000W 2 kW 5/4 WITH THERMOSTAT

Special features:

Heater power: 2000 W
Thread: 5/4 inch
Temperature adjustment range: from 30 to 65 degrees C +/-5 degrees C
Supply voltage: 230 V AC

The heater with temperature controller is used as the primary heat source in typical bathroom radiators, e.g. ladder, panel, etc. It is also used as an additional (spring-summer) heat source in radiators operating in central heating systems. Generally, it is used for water heating.

DIMENSIONS:

total length: 480 mm
heating capillary length: 350 mm
capillary diameter: 8 mm
thread length: 13 mm
power cable length: 1.5 m

OPERATING NOTES

heaters intended for use in galvanized or enameled steel tanks must not be used in stainless steel tanks
the heater must be installed so that the entire element is always submerged in liquid - it should always be installed at the bottom of the device
connect to power only after filling the device with liquid
to optimally and economically select the heater, the heat output provided by the manufacturer of the radiator should be matched with the electrical power of the heater - use heaters with power slightly lower (100 - 150 W) than the radiator's heat output
the control lamp lighting indicates heating; after reaching the temperature set by the knob, the lamp goes out
do not screw in while holding the plastic housing (risk of breaking)
extension of the connection cable should be entrusted to an authorized service point
stainless steel heaters must be galvanically isolated from the tank (grounded or neutralized) to avoid electrochemical corrosion. This task should be performed by a person with SEP qualifications

NOTE REGARDING HEATER SELECTION ACCORDING TO WARRANTY CONDITIONS

According to the recommendations and warranty conditions, the power selection relative to the tank capacity should be calculated with a minimum coefficient of 18 Watts/liter.

A properly selected heater will heat the capacity in about 2-3 hours and then calmly regenerate the insulation of the heating coil, waiting for the next heating cycle. For heaters with too low power, not compliant with the 18 Watts/liter recommendation, operation causes continuous work and overheating of the heating element and controller contacts, leading to premature failure.

For proper heater operation, always use the highest possible heater power according to the above formula / coefficient 18 W/liter

Optimally 1500 W for tanks up to 80 liters (80 liters x 18 Watts/liter = 1400 W heater power)

2000 W for tanks up to max 120 liters

3000 W (STANDARD version) for max 160 liters

Larger tanks or commercial use should use 3000W heaters LONG version, as follows:

For tanks above 180 – 300 liters, we strongly recommend (especially for photovoltaics) using a 3 KW heater, but in the LONG version

Product safety information Manufacturer information

Recommended

Recently viewed products